Global Machinery Company DP250LS Manuel d'utilisateur

11/3 HP 5 SPEED DRILL PRESS WITH REDEYE® DP250LSINSTRUCTION MANUALBlackCyanMagentaYellowCode: DP250LSDate: 071120 Edition: 05 Op: DCR

102. Tilt the table to the desired angle as indicated on the bevel scale.3. Tighten the screw under the table by rotating it in a clockwise direction.

11Changing the speed of the drill pressThe speed of the drill press is determined by the size of the pulley steps that the belt is attached to. Using

12Turning on the REDEYE® laser line generator1. The REDEYE® laser line generator emits two intense narrow beams of pure red light that intersect at t

13Wood drilling• For maximum performance, use high speed steel bits for wood drilling.• Secure the workpiece to prevent it from turning when drill

14Trouble shootingWARNING. Turn the on/off switch to the off position and unplug the tool from the power supply before performing trouble shooting pro

15

GMC customer assistIf your product needs repairing, replacing, technical service or you simply need help or advice, please contact us on our Customer

2ContentsWarranty 2Introduction 3Environmental protection 3Description of symbols 3Specifications 3Safety rules for laser lights 4General safety

3Description of symbolsThe rating plate on your tool may show symbols. These represent important information about the product or instructions on it

4Safety rules for laser lightsThe laser light/laser radiation used in the GMC REDEYE® system is Class 2 with maximum 1mW power and 650nm wavelengths.

57. Dress correctly. Do not wear loose clothing or jewellery. They can be caught in moving parts. Rubber gloves and non-slip footwear are recommended

65. Always keep hands out of the path of the drill bit. Avoid awkward hand positions where a sudden slip could cause your hand to move into the drill

7UnpackingDue to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything

8Know your product1. Laser light on/off switch2. Laser aperture (x2)3. On/off switch4. Pulley cover5. Pulley cover knob6. Base7. Column8. Table/Suppor

9Assembly1. Place base (6) on floor.2. Place column assembly (7) on base and align the 3 holes in the column assembly with the holes in the base.3. Us