PRTABLE031219 ED12 DRINSTRUCTION MANUAL1050WPowered Router Table• Melbourne • Perth • Auckland • Hong Kong • Shanghai • Taipei • New York • Verona • L
AdjustmentsAdjusting the speed1. Adjust the variable speeddial (9) to suit differentmaterial. The tool cutsquicker and smoother atdifferent speeds and
Adjusting the fence for trimming1. When trimming timber the material coming out on theleft hand side (outfeed) (4) of the cutter will bethinner than t
Adjusting the mitre gauge1. The mitre gauge (10) slides horizontally along thetable to allow for edging and mitre cuts in the workpiece.2. To adjust t
Operation1. Insert and secure the router bit.2. Adjust the speed, depth of cut, feather boards, fencealignment and mitre gauge as required.3. Ensure y
Carefully read the entire Instruction Manual before using this product.Before returning this product for a Warranty Claim or any other reason Please C
Contents
Description of symbolsThe rating plate on your tool may show symbols. Theserepresent important information about the product orinstructions on its use
General safety instructionsThe tool must be used only for its prescribed purpose. Anyuse other than those mentioned in this Manual will beconsidered a
15. Avoid unintentional starting. Always check that theswitch is in the OFF position before plugging in thetool to the power supply. Do not carry a pl
• Before using the tool to make a cut, switch on and letit run for a while. Watch for vibration or wobbling thatcould indicate an improperly installed
Know your product1. Table2. Rear fence3. Infeed fence4. Outfeed fence5. Fence locking knobs6. Guide block locking knobs7. Dust extraction hood8. Dust
Installing and removing colletsWarning. Always ensure the tool is switched off and theplug is removed from the power point before making anyadjustment
11. Replace the collet assembly cover in the followingway:11. The collet assembly coverlocates in the centre ofthe height adjusting ringand is secured
Commentaires sur ces manuels