POL1450030901 Ed8 DR
9. To tighten, press and hold the spindle lock button (2)and using the pin wrench tighten the outer flange.10. Turn the new disc by hand, ensuring tha
11Operation in sander modeFitting the SandpaperSwitch off the tool and disconnect it from the powersupply.1. The GMC grinder/sander/polisher is fitted
12Operation in polisher modePrepare the surfaceFor best results, the surface should be clean and dry. Mosthigh-gloss surfaces can be cleaned with a mi
sponge, polishing bonnet and the tool are in goodcondition. Plug the cordset into the mains socket.3. Do not overload the tool so that the disc slows
14
Carefully read the entire Instruction Manual before using this product.Before returning this product for a Warranty Claim or any other reason Please C
ContentsWarranty 2Introduction 3Environmental protection 3Description of symbols 3Specifications 3Safety instructions 4Additional safety rules for san
Description of symbolsThe rating plate on your tool may show symbols. Theserepresent important information about the product orinstructions on its use
Safety instructionsThe tool must be used only for the prescribed purpose.Any uses other than those mentioned in this manual willbe considered a case o
9. Connect dust extraction equipment. If devices areprovided for the connection of dust extraction andcollection facilities, ensure that these are con
6• Check the disc before mounting it into the anglegrinder. Check by striking it with a wooden handlewhilst balancing the disc on your finger. Listen
• When sanding wood, always connect the dust bag oruse a dust extraction system.• Before using the sander with metal, always remove thedust bag from t
Know your productBefore using the polisher, familiarise yourself with all the operating features and safety requirements.Use the tool and accessories
Setting upMulti position front handleScrew the multi position fronthandle (9) into the mostsuitable mounting point (6)(left side, right side or at the
Commentaires sur ces manuels